Press and Hold - designed to be used in the following situations - On/Off, Menu, Night Vision Mode.īy rotating the Diopter Adjustment Ring you will achieve optimal sharpness for your vision.Short and Quick Taps - used for most functions and to navigate the menu.The keypad is programmed to be used in two different ways: Press and hold the Power button for 3-5 seconds wait 5-10 seconds and to Turn On the device. If the scope freezes or stops responding to the control panel. To Turn Off the device press and hold the Power button.
To Turn On the device press and hold power button until you hear a click (3-5 seconds). Battery run time is 10 hours on a single charge.Battery charging time (from 0 to 100%) is 6 hours with 2 A USB charger.Recommended charger is 2 A USB charger.Note using a wall charger with lower amperage will take longer to charge your scope. Plug the cable into a USB wall charger that has an output of 2 amps (Wall Charger not included).Ĭharge your scope for 6 hrs using a 2 A USB wall charger. We have included a USB (type C) charging cable with your scope. You will find it under the rubber cap on the right side of the device. The device is equipped with a USB (type C) port for charging. If any accessories are missing or broken contact ATN’s Customer Service at 1.800.910.2862. Ensure that all optical surfaces are clean and ready for use.Inspect the device for damage to optical surfaces, body, eyecups, operation buttons, etc.Open packaging box, remove X-Sight LTV and check the contents.The following steps must be performed before using the device: Download this manual (.PDF, 1.94 Mb) Unpacking
0 kommentar(er)
